Layer 2 IEEE 802.3at standard(PoE+) Intelligent Giga Switch 24/16/8-Port Model
BS-POE-G21M
The BS-POE-G21M Intelligent Giga Switch fratures Gigabit interfaces for all ports.This supports VLAN,QoS,and wide variety of other functins enabling flexible nerwork configurations,making this an optimal switch for aggregating separate hubs.Comes in 24-,16-,and 8-port models.
BS-POE-G2124M
BS-POE-G2116M
BS-POE-G2108M
LEDs indicate establishment of Gigabit link
The LED lights when a link is established with another device.The LEDs turn green when a Gigabit connection is established and orange when a 100-Mbps link is confirmed.These indicators allow you to check the status of each port's connection at a glance.
The BS-POE-G21M is compatible with Jumbo Frames,larger Ethernet data packets used to increase the efficiency of transfers over netoworks.This enables fuller utilization of Gigabit transmissions in achieving high-speed transfers.*Jumbo Frames:9,216bytes
*Requires jumbo frame be supported by all devices in transmission circuit.
Supports Variety of Authentication Functions Permitting Only Authorized Users to Connect
The BS-POE-G21M supports IEEE 802.1X/EAP authentication,which when used with a RADIUS server allows only users with proper access to connect to the network.
Also supported are Web authentication and MAC address authentication requiring no supplicant.
A Variety of Qos (Quality of Service)Functions to Control Signal Priority
Today's office networks carry a mix of widely differing applications,necessitating various QoS functins to distinguish the relative importance of the transmissions.The BS-POE-G21M provides four levels of QoS based on the IEEE 802.1 standard,while also supporting DSCP/IP Precedence.These functions can be used to suit any particular need.
Reduce Energy Consumption with Low Power Idle Mode
In addition to the energy-saving adjustments based on link status and cable length,the Low Power ldle mode cuts energy consumption at times when there is no data being transmitted.Use of Power ldle mode can cut energy consumption up to 29% when all ports are in use,and up to 38% when no ports are in use.
*Comparison of energy consumption for BS-POE-G2124M.
*Figures represent model case of traffic history in BUFFALO studies and do not necessarily indicate actual power consumption.
* Wattmeter: YOKOGAWA WT210,Test load devices:OPTIXIA XM2,LSM1000MV16,LSM1000XMS12,all LAN cables minimum 3 meters,all ports connected Data was transferred from the test load device to the switching hub at wire speed and power consumption measured 1 minute after the start of the transfer.Measurements were performed 3 times,with averaged values for the 3 measurements used as the measured result.(Testing performed by BUFFALO Auguust 2012)
Loops Indicated by Flashing LEDs and Buzzer
UL60950-1 safety standard certified
As proof of design safety by a third-party organization,these switches are UL-listed (UL60950-10),approved by Underwriters Laboratories.
Conveniently designed to meet a variety of installation needs
PoE Profiler Function Checks Wasted PoE Power
Turns PoE on and off at specified times or days of the week.Cuts wasteful power use.
The PoE Profiler function turns the PoE power supply on and off at specified times or days of the week.This makes it easy to reduce wasteful power use by stopping PoE supplies,for example at night and days off,when wireless access points are not used much.
Swtiches Feature a Variety of Functions
-Compliant with IEEE802.3ab (1000BASE-T)/IEEE802.3u (100BASE-TX)/IEEE802.3 (10BASE-T)standards
-All ports feature 1000M/10M/100M Full-Duplex/Half-Duplex functions
-All ports feature 1000M/10M/100M Auto-Negotiation functions
-Supports IEEE 802.3X,flow control (with Full-Duplex),back pressure (with Half-Duplex)
-LEDs allow Link/Active,1000M/100M/10M,and power status to confirmed visually
-Error Frame Filtering
-Store-and-Forward transmission for highly reliable switching
AC Cable Hook Prevents Disconnection
Optimal for Configuring Secure Networks
The switches support the "EAPOL (IEEE 802.1X frame) pass"security function required in MAC-based IEEE 802.1X authentication environments.This is Optimal for Configuring Secure Networks.Also supported is the "BDPU pass" function required for redundant networks.
No More Messy Outlets
The internal power supply means no AC adapters are needed,so normally messy outlets are now tidy and clear.
Automatically Distinguishes Between Straight and Crossover Cables
The units feature Auto-MDIX to automatically distinguish between connected straight and crossover LAN cables.This prevents problems from mistakes in connecting,thus helping to reduce repair and maintenance costs.
RoHS Compliant
This product complies with the "RoHS D irective,"a directive implemented in the EU since July 2006 that places restrictions on the use of specified hazardous substances in manufacturing electronic equipment.
Hardware Overview
Dimensions
*Values are in milimeters.
Model
Name | BS-POE-G21M |
---|
LAN Interface
Standard Compliance | IEEE 802.3 (10BASE-T),IEEE 802.3u (100BASE-TX),IEEE 802.3ab (1000BASE-T), IEEE802.3z (1000BASE-SX/1000BASE-LX) |
---|---|
Speed and Flow Control | 10/100/1000 Mbps |
Data Transfer Method | Store-and-Forward (S/F) |
Latency | [BS-POE-G2108M]4.5 usec (w/1000M,64-byte,S/F),[BS-POE-G2116M] 4.5 usec (1000M,64-byte,S/F),[BS-POE-G2124M] 4.7 usec (1000M,64-byte,S/F) |
Buffer Capacity | 512 KB |
Flash Memory | 8 MB |
Main Memory | 64 MB |
Channel Coding Scheme | Manchester coding (10BASE-T),4B5B/MLT-3 (100BASE-TX),4D-PAM5 (1000MASE-T) |
Access Method | CSMA/CD |
Data Transfer Rate | 14,881 packets/s (10BASE-T), 148,810 packets/s(100BASE-TX), 1,488,095 packets/s (1000BASE-T) |
Address Table | 8,192 addresses (aging time:300 seconds) |
MAC Address Learning Method | SVL |
PoE Connection Method | Alternative A |
Number of Terminals | [BS-POE-G2108M] 10/100/1000:8 ports(all ports feature Auto-MDIX function) [BS-POE-G2116M] 10/100/1000:16 ports(all ports feature Auto-MDIX function) [BS-POE-G2124M] 10/100/1000:24 ports(all ports feature Auto-MDIX function) |
Compatible Cables | 10BASE-T:UTP/STP Category 3 and above; 100BASE-TX; UTP/STP Category 5 and above; 1000BASE-T:UTP/STP Category 5e and above |
Transmission Distance | Maximum 100 m |
Port shape | RJ-45 |
SNMP | Supported |
Console Port | RS-232C(RJ-45) |
Number of VLANs | 256(VLAN ID:1-4,094) |
Others
Dimensions(W × H × D) | ) [BS-POE-G2108M]270 × 231 × 43 mm,[BS-POE-G2108M]330 × 231 × 43 mm, [BS-POE-G2124M]440 × 257 × 43 mm |
---|---|
Weight | [BS-POE-G2108M]2.5kg,[BS-POE-G2108M]3.0kg,[BS-POE-G21024M]4.1kg |
Power Consumption | [BS-POE-G2108M] Max 211W,[BS-POE-G2108M] 260W,[BS-POE-G2124M] 266 W |
Power Supply | 100-240 V,50/60 Hz |
You can compare the specifications of the product in this page. Click the model which you want to compare and click the “Compare”button.